QN-249 · A small old copper deposit (classed as small in the authors' summary; old mine workings and an old open pit are present); infiltration-type copper mineralization (as defined by the authors of the source) — malachite and azurite as crusts and coatings along fractures in tuffaceous sandstones (in the richest places they fill fractures up to 2–3 cm wide); in amygdaloidal porphyrites malachite, besides coatings, fills small cavities and amygdales
Copper — Pavlodar Region
Copper reserves from a past-years estimate (past-years classification), categories C1 + C2:
10,529 t of metal (the deposit was mined; the remainder of the reserves after mining is not shown in our materials)
- Host rocks and age: an effusive-clastic sequence (albitophyres, their tuffs, felsite porphyries) and a volcanogenic-sedimentary sequence (tuffs, tuffites, diabase and andesite-dacite porphyrites, tuffaceous sandstones) of the Lower and Middle Devonian; a significant part of the area is covered by loose Quaternary deposits. Ore-bearing rocks: tuffaceous sandstones and amygdaloidal porphyrites
- Structural control: mineralization is confined to a crushed contact of tuffaceous sandstones and porphyrites in a small gently dipping trough (limbs dipping at 30–40°, thickness of rocks in the trough 30 m); Devonian rocks make up a limb of a structure of latitudinal strike complicated by small folds and numerous faults. The highest copper contents are confined directly to the crushed contact and to zones of crushed limonitized rocks near the contact. Ore zone II lies in the same trough (strike 60–80°) and looks like a continuation of ore zone I
- Dimensions: ore zone I is outlined by mine workings — length 400 m, width 200 m; according to drill holes the thickness of the zone is 6–9 m (a handwritten correction in the source). Ore zone II: width 40 m, length 200 m (from three test pits). According to the authors' summary, the area of the trough at the surface is 900 × 200 m, and the ore-bearing horizon on the site is largely eroded
- Ore zone I, surface mine workings: copper content is extremely uneven, limits from 0.1 to 2%; averages per the source — copper 0.5%, molybdenum 0.002% (value entered by hand), lead 0.06%. The number of workings and samples behind the average is not stated
- Ore zone I, core of five drill holes (depth up to 66 m, inclination 85°): copper 2–5% in core from the zone, as stated in the source; the range, the average by drill holes and the core recovery are not stated
- Ore zone II and the remaining halos: three test pits exposed crushed amygdaloidal porphyrites with copper mineralization similar to zone I; one drill hole intersected the zone at a thickness of 5.5 m, and two other drill holes (at distances of 100 and 150 m) found no mineralization. The remaining halos were checked by individual test pits and trenches: weakly mineralized rocks were exposed, with copper contents on the order of hundredths and tenths of a percent
- Secondary dispersion halos from a metallometric survey (not grades in ore): copper 0.01–1%, molybdenum 0.001%, lead up to 0.04%, silver up to 0.001%; the area of the scattered halos is 11.2 sq. km — much larger than the deposit itself
- Ore minerals and associated components: malachite and azurite; the associated molybdenum, lead and silver are named only as averages for zone I and in the halos (values above)
- Degree of study: prospecting and exploration work — test pits, trenches and five drill holes along a flank of ore zone I; then a comprehensive geochemical and geophysical survey at a scale of 1:10,000 (metallometry, magnetic survey, electrical profiling, spontaneous potential, geological mapping, mining and sampling work, a small volume of induced polarization). Ore zones I and II were checked by mine workings and drill holes, the remaining halos only partly. There is no later work in our materials
- Reserves from a past-years estimate (past-years classification), metal — copper: category C1 — 9,886 t, category C2 — 643 t, total 10,529 t. Caveat: according to the summary the deposit was mined, and our materials contain no information on the amount extracted, the remainder of the reserves after mining or any recalculation of the reserves; by whom and when the estimate was approved is not stated. There is no predicted-resource estimate for the site
Report fragments
Source: archival geological reports (scans in our archive)