Skip to content

QN-226 · A crush, silicification and ochre-staining zone with elevated lead and molybdenum contents, confined to the main branch of a major fault; no visible mineralization other than ochre staining is observed in the zone

Lead, molybdenum, zinc — Almaty Region

Average for a four-meter interval, chemical analysis (working and number of samples not stated):

lead 0.25%

  • Host rocks: quartz diorites, intensely crushed, silicified and ochre-stained in the zone; on the flanks the zone goes under a piedmont blanket 25–35 m thick of sandy loams with fine clastic material
  • Structural control: a crush zone along one of the main branches of a major fault, at the foot of a tectonic scarp; dip angle 70°
  • Dimensions: the thickness of the crush zone exposed by the trench is 6.5 m; the zone is exposed only in the channel and wall of a gully; along strike it has been traced by a profile of auger drill holes
  • Grades, spectral analysis over the whole thickness of the zone (order of magnitude): lead 0.015–0.2%, zinc 0.1%, molybdenum in two samples 0.01–0.02%
  • Grades, chemical analysis: average lead content for a four-meter interval 0.25% (the working and the number of samples are not stated); molybdenum in two samples 0.01–0.029%; gold was not detected by spectral gold analysis
  • Auger drill holes (two drill holes on the scarp in the relief of Paleozoic rocks): lead 0.01–0.06%, zinc 0.02–0.04% (ranges of values)
  • Ore minerals: not named (no visible mineralization); associated component — zinc
  • Level of study: a trench, a test pit 4.5 m deep, a profile of auger drill holes (spacing 5–10 m, depths 8–10 m), spectral and chemical analysis
  • Reserves and predicted resources are not given

Report fragments

Source: archival geological reports (scans in our archive)

Location

The place is shown approximately: the object lies inside the circle. The exact place and materials follow a meeting.Region boundaries: © OpenStreetMap contributors, geoBoundaries (ODbL)
Contact